The security settings of your browser do not allow writing cookie information.
This is a requirement to place an order with my-wall-decal.com.
You can change your security settings at any time. Therefore please have a look at our help page.
-
- 0My shopping cart $ 0.00
Subtotal:$ 0.00
1-781-592-1694 - 10 a.m.-4 p.m. [EST]
The Wall Decal Shop Wall Decals - Wall Stickers - Wall Art
Manuals for working with our products
Manual for affixing Wall Decals
Preparation
- Please read the instructions thoroughly before you start.
- Assure that the surface you want to affix the Wall Decal to, is dry and free of dust and grease.
- If necessary, mark the corners of the designated area using a pencil.
Hints
- If your wall is freshly painted, please wait approx. 3 weeks until the paint has thoroughly dried.
- Most of our Wall Decals can be affixed individually. Just cut the individual parts using scissors.
- When applying a big Wall Decal or Wall Print be sure to get help affixing it to the wall.
- When storing the Wall Decal or Wall Print make sure to place in a dry and clean area, between 50° F to 85° F.
Smooth out the backing paper using your hands or a plastic squeegee, to ensure the design adheres to the application tape.
Step
1Carefully remove the backing paper at a flat angle to ensure the decal remains adhered to the application tape.
Step
2Affix the Wall Decal to the desired location with the adhesive side facing the surface.
Step
3Smooth out the application tape using your hands or a plastic squeegee to ensure the decal is properly applied to the surface.
Step
4Please pay special attention to the edges and small details.
Step
5Carefully peel off the application tape at a flat angle.
Step
6Please peel slowly...
Step
7If parts are not affixed to the wall properly press them on with your fingers or a squeegee.
Step
8Completely remove the application tape.
Step
9After removing the application tape, press on your Wall Decal firmly using a towel or lint-free cloth!
For full color items smoothen out the edges of the decal after a few hours.
For full color items smoothen out the edges of the decal after a few hours.
Step
10Note! For best results, we suggest to use a blow dryer at the lowest setting to warm up the film and smoothen out the Decal. This takes a little more time, but the results are even better. The Decal will appear like it is painted on the wall.
Manual for working with Wall Prints
Preparation
- Please read the instructions thoroughly before you start.
- Assure that the surface you want to affix the Wall Decal to, is dry and free of dust and grease.
- If necessary, mark the corners of the designated area using a pencil.
- Place the Wall Print onto a smooth sand even surface (e.g. table / floor) with the white backing paper on top, Wall Print facing down.
- Carefully peel off approx. 4 inches of the backing paper starting on top of the Wall Print and fold down the loose part of the backing paper.
Step
1- Adjust your Wall Print using the pencil marks and carefully peel off the backing paper step by step, while smoothing out the Wall Print with a soft towel.
- Smooth out the corners and edges of the Wall Print.
- Repeat the last step after 24 hours.
Step
2
